ال عداد البرق is suitable for the discharge counting of various lightning protection devices. Using flash memory storage mode, the data will never be lost after power failure. Embedded circuit boards can be designed according to needs, matching various devices, and there have been successful cases applied to lightning protection boxes, railway power supplies, and communication power supplies. Instructions for use: 1. Please charge before use. In order to ensure the charging effect and prolong the battery life, it is necessary to use a special charger. It takes about 3-4 hours to fully charge the battery. A red light on the charger means charging is in progress; a green light means charging is complete. 2. According to the installation height of the counter, properly pull out the telescopic discharge rod. 3. Dedicated ground wire. One end of the plug goes into the jack on the end of the calibrator and the other end clips to the ground. 4. Press the red button, turn on the high voltage for about 1 second, the indicator light is on (flickering slightly). ال test can be done by lightly clicking on the connections of the counter and arrester. 5. ال end of the discharge rod should leave the counter after each click. If the test needs to be repeated, do not release the button. When the light flashes again for 1-2 seconds, click Test again. 6. Continuous testing will cause the calibrator to heat up. Please note the appropriate gap time. to reduce failures and extend battery life. 7. ال output of the calibrator is divided into three grades: high, medium and low, which can be adjusted by the toggle switch on the head to adapt to testing counters of different models or brands. 8. If the button is pressed for more than 3 seconds and the indicator light is still off, it means the battery needs to be charged. 9. Do not disassemble the calibrator at will. If the capacity of the battery pack has decreased significantly or the charging efficiency is too low, it needs to be replaced. Please purchase a special battery pack from our company.
الوقت بعد: Aug-29-2022